Global Vlan1Q Tagged Vlan Configuration Commands; Garp Status; Garp Timer - ZyXEL Communications ZyXEL Dimension ES-4124 User Manual

Chapter 49 IEEE 802.1Q Tagged VLAN Commands

49.2 Global VLAN1Q Tagged VLAN Configuration Commands

This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.

49.2.1 GARP Status

Syntax:
show garp
This command shows the Switch's GARP timer settings, including the join, leave and leave all
timers.
An example is shown next.
sysname# show garp

GARP Timer

------------------------
Join Timer = 200
Leave Timer = 600
Leave All Timer = 10000
sysname#
49.2.2 GARP Timer
Syntax:
garp join <msec> leave <msec> leaveall <msec>
where
join <msec>
leave <msec>
leaveall
<msec>
This command sets the Switch's GARP timer settings, including the join, leave and leave all
timers.
Switches join VLANs by making a declaration. A declaration is made by issuing a Join
message using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All
message terminates all registrations. GARP timers set declaration timeout values.
414
= This sets the duration of the Join Period timer for GVRP in
milliseconds. Each port has a Join Period timer. The allowed Join Time
range is between 100 and 32767 milliseconds; the default is 200
milliseconds.
= This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time
must be two times larger than Join Timer; the default is 600
milliseconds.
= This sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All
Timer must be larger than Leave Timer; the default is 10000
milliseconds.
ES-4124 User's Guide