ES-3148 User's Guide
38.2 Global VLAN1Q Tagged VLAN Configuration Commands
This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.
38.2.1 GARP Status
Syntax:
This command shows the switch's GARP timer settings, including the join, leave and leave all
timers.
An example is shown next.
sysname # show garp
GARP Timer
------------------------
Join Timer = 200
Leave Timer = 600
Leave All Timer = 10000
sysname#
38.2.2 GARP Timer
Syntax:
where
join <msec>
leave <msec>
leaveall
<msec>
This command sets the switch's GARP timer settings, including the join, leave and leave all
timers.
294
show garp
garp join <msec> leave <msec> leaveall <msec>
=
This sets the duration of the Join Period timer for GVRP in
milliseconds. Each port has a Join Period timer. The allowed Join Time
range is between 100 and 32767 milliseconds; the default is 200
milliseconds.
=
This sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time
must be two times larger than Join Timer; the default is 600
milliseconds.
=
This sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All
Timer must be larger than Leave Timer; the default is 10000
milliseconds.
Chapter 38 IEEE 802.1Q Tagged VLAN Commands