Dimension GS-3012 Gigabit Ethernet Switch
The following procedure shows you how to configure tagged VLAN.
Use the IEEE 802.1Q tagged VLAN commands to configure tagged VLAN for the switch.
3.
•
Use the
vlan <vlan-id>
automatically enters the
•
Use the
command when you are finished configuring the VLAN.
exit
•
Use the
interface <port-list> command
on a port, then use the pvid <vlan-id> command to set the VLAN ID you created for the port-list to
that specific port in the PVID table.
•
Use the
inactive
Example:
GS-3012 (config)# vlan 2000
GS-3012 (config-vlan)# name up1
GS-3012 (config-vlan)# fixed 10-12
GS-3012 (config-vlan)# no untagged 10-12
GS-3012 (config-vlan)# exit
GS-3012 (config)# interface 10-12
GS-3012 (config-interface)# pvid 2000
GS-3012 (config-interface)# exit
Figure 30-1 Tagged VLAN Configuration and Activation Example
Configure your management VLAN.
4.
•
Use the
vlan <vlan-id>
and the switch will activate the new management VLAN.
•
Use the
inactive
Example:
GS-3012 (config)# vlan 3
GS-3012 (config-vlan)# inactive
Figure 30-2 CPU VLAN Configuration and Activation Example
30.4 Global VLAN1Q Tagged VLAN Configuration Commands
This section shows you how to configure and monitor the IEEE 802.1Q Tagged VLAN.
30.4.1
GARP Status
30-2
command to configure or create a VLAN on the switch. The switch
mode.
config-vlan
command to deactivate the VLAN(s).
command to create a VLAN (VID 3 in this example) for managing the switch,
command to disable the new management VLAN.
to enter the config-interface mode to set the VLAN settings
IEEE 802.1Q Tagged VLAN Commands