Figure 131 Ip Application > Igmp; Table 93 Ip Application > Igmp - ZyXEL Communications ZyXEL Dimension ES-4124 User Manual

Chapter 29 IGMP
Figure 131 IP Application > IGMP
The following table describes the labels in this screen.
Table 93 IP Application > IGMP
LABEL
Active
Unknown
Multicast
Frame
Index
Network
Version
Apply
Cancel
248
DESCRIPTION
Select this check box to enable IGMP on the Switch.
Note: You cannot enable both IGMP snooping and IGMP at the same
time. Refer to Section 22.4 on page 178
IGMP snooping.
Specify the action to perform when the Switch receives an unknown multicast frame.
Unknown multicast frames are addressed to multicast groups for which the Switch has
not recorded any group members. Select Drop to discard the frame(s). Select Flooding
to send the frame(s) to all ports.
This field displays an index number of an entry.
This field displays the IP domain configured on the Switch.
Refer to Section 7.6 on page 81
Select an IGMP version from the drop-down list box. Choices are IGMP-v1, IGMP-v2,
IGMP-v3 and None.
Generally, if you want to enable IGMP on the Switch, you should choose IGMP-v3 as it
is compatible with older versions. Choose an earlier version of IGMP (IGMP-v2 or
IGMP-v1) if the multicast hosts on your network can not recognize IGMP version 3 or
version 2 Query messages.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
for more information on
for more information on configuring IP domains.
ES-4124 User's Guide