ZyXEL Communications ZyXEL Dimension ES-4124 User Manual page 368

Chapter 45 Introducing Commands
Table 141 Command Summary: Configuration Mode (continued)
COMMAND
ospf <router-id>
368
DESCRIPTION
Leaves the IGMP configuration
exit
mode.
Sets the Switch to Non-Querier
non-querier
mode. (If a multicast router with
a lower IP address, it will stop
sending Query messages on
that network.)
Disables non-querier mode on
no non-querier
the Switch, (a multicast router
always sends Query messages).
Specifies the action the Switch
unknown-
should perform when it receives
multicast-frame
unknown multicast frames.
<drop|flooding>
Enables and enters the OSPF
configuration mode.
Enables and sets the area ID.
area <area-id>
Enables simple authentication
area <area-id>
for the area.
authentication
Enables MD5 authentication for
area <area-id>
the area.
authentication
message-digest
Sets the cost to the area.
area <area-id>
default-cost
<0-16777214>
Sets a descriptive name for the
area <area-id>
area for identification purposes.
name <name>
Enables and sets the area as a
area <area-id>
stub area.
stub
Sets the stub area not to send
area <area-id>
any LSA (Link State
stub no-summary
Advertisement).
Sets the virtual link ID
area <area-id>
information for the area.
virtual-link
<router-id>
Enables simple authentication
area <area-id>
and sets the authentication key
virtual-link
for the specified virtual link in the
<router-id>
area.
authentication-
key <key>
Sets the virtual link to use the
area <area-id>
same authentication method as
virtual-link
the area.
<router-id>
authentication-
same-as-area
Enables MD5 authentication and
area <area-id>
sets the key ID and key for the
virtual-link
virtual link in the area.
<router-id>
message-digest-
key <keyid> md5
<key>
PRIVILEGE
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
ES-4124 User's Guide