ZyXEL Communications ZyXEL Dimension ES-4124 User Manual page 376

Chapter 45 Introducing Commands
Table 142 interface port-channel Commands (continued)
COMMAND
bpdu-control
<peer|tunnel|disc
ard|network>
broadcast-limit
dhcp snooping
trust
dhcp snooping
limit rate <pps>
diffserv
dlf-limit
egress set <port-
list>
ethernet oam
exit
376
DESCRIPTION
Enables bandwidth limits allowed
egress
for outgoing traffic on the port(s).
Sets the maximum bandwidth
egress <Kbps>
allowed for outgoing traffic on the
port(s).
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
Enables broadcast storm control
limit on the Switch.
Specifies the maximum number
<pkt/s>
of broadcast packets allowed to
pass through this port per
second. Broadcast packets
above this threshold are dropped
by the Switch.
Sets this port as a trusted DHCP
snooping port. Trusted ports are
connected to DHCP servers or
other switches, and the Switch
discards DHCP packets from
trusted ports only if the rate at
which DHCP packets arrive is too
high.
Sets the maximum rate that
DHCP packets are allowed to
arrive at a trusted DHCP
snooping port.
Enables DiffServ on the port(s).
Enables the Destination Lookup
Failure (DLF) limit.
Sets the interface DLF limit in
<pkt/s>
packets per second (pps).
Sets the outgoing traffic port list
for a port-based VLAN.
Enables Ethernet OAM on the
port(s).
Specifies active or passive OAM
mode
mode on the ports. Active mode
<active|passive>
allows the port to issue remote
loopback and discovery
commands. Passive mode
means that the port can only
respond to Ethernet OAM
commands.
Enable Ethernet OAM remote-
remote-loopback
loopback capability on the
supported
port(s).
Exits from the interface port-
channel command mode.
PRIVILEGE
13
13
13
13
13
13
13
13
13
13
13
13
13
13
13
ES-4124 User's Guide