ZyXEL Communications ZyXEL Dimension ES-4124 User Manual page 155

Table 43 Advanced Application > Classifier (continued)
LABEL DESCRIPTION
Ethernet Select an Ethernet type or select Other and enter the Ethernet type number in
Type hexadecimal value. Refer to
Source
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a source, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Port Type the port number to which the rule should be applied. You may choose one port only
or all ports (Any).
Destination
MAC Select Any to apply the rule to all MAC addresses.
Address
To specify a destination, select the second choice and type a MAC address in valid MAC
address format (six hexadecimal character pairs).
Layer 3
Specify the fields below to configure a layer 3 classifier.
DSCP Select Any to classify traffic from any DSCP or select the second option and specify a
DSCP (DiffServ Code Point) number between 0 and 63 in the field provided.
IP Select an IP protocol type or select Other and enter the protocol number in decimal value.
Protocol Refer to
You may select Establish Only for TCP protocol type. This means that the Switch will
pick out the packets that are sent to establish TCP connections.
Source
IP Enter a source IP address in dotted decimal notation.
Address/
Specify the address prefix by entering the number of ones in the subnet mask.
Address
Prefix
Socket
Number
Destination
IP Enter a destination IP address in dotted decimal notation.
Address/
Specify the address prefix by entering the number of ones in the subnet mask.
Address
Prefix
Socket
Number
Add Click Add to insert the entry in the summary table below and save your changes to the
Switch's run-time memory. The Switch loses these changes if it is turned off or loses
power, so use the Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Clear Click Clear to set the above fields back to the factory defaults.
ES-4124 User's Guide
Table 46 on page 157
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second
option and enter a TCP/UDP protocol port number.
Note: You must select either UDP or TCP in the IP Protocol field before
you configure the socket numbers.
Select Any to apply the rule to all TCP/UDP protocol port numbers or select the second
option and enter a TCP/UDP protocol port number.
Table 45 on page 156 for information.
for more information.
Chapter 18 Classifier
155