Figure 63 Advanced Application > Link Aggregation > Link Aggregation Setting > Lacp; Table 39 Advanced Application > Link Aggregation > Link Aggregation Setting > Lacp - ZyXEL Communications ZyXEL Dimension ES-4124 User Manual

Figure 63 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
The following table describes the labels in this screen.
Table 39 Advanced Application > Link Aggregation > Link Aggregation Setting > LACP
LABEL
Link
Aggregation
Control
Protocol
Active
System
Priority
Group ID
LACP Active
Port
ES-4124 User's Guide
DESCRIPTION
Note: Do not configure this screen unless you want to enable
dynamic link aggregation.
Select this checkbox to enable Link Aggregation Control Protocol (LACP).
LACP system priority is a number between 1 and 65,535. The switch with the lowest
system priority (and lowest port number if system priority is the same) becomes the
LACP "server". The LACP "server" controls the operation of LACP setup. Enter a
number to set the priority of an active port using Link Aggregate Control Protocol
(LACP). The smaller the number, the higher the priority level.
The field identifies the link aggregation group, that is, one logical link containing
multiple ports.
Select this option to enable LACP for a trunk.
This field displays the port number.
Chapter 15 Link Aggregation
139