Multiple Rapid Spanning Tree Protocol Status; Figure 55 Advanced Application > Spanning Tree Protocol > Status: Mrstp; Table 29 Advanced Application > Spanning Tree Protocol > Status: Mrstp - ZyXEL Communications ZyXEL Dimension ES-4124 User Manual

Table 28 Advanced Application > Spanning Tree Protocol > MRSTP (continued)
LABEL
Apply
Cancel

11.7 Multiple Rapid Spanning Tree Protocol Status

Click Advanced Application > Spanning Tree Protocol in the navigation panel to display
the status screen as shown next. See
MRSTP.
This screen is only available after you activate MRSTP on the Switch.
Figure 55 Advanced Application > Spanning Tree Protocol > Status: MRSTP
The following table describes the labels in this screen.
Table 29 Advanced Application > Spanning Tree Protocol > Status: MRSTP
LABEL
Configuration
Tree
Bridge
Bridge ID
Hello Time
(second)
ES-4124 User's Guide
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
Section 11.1 on page 109
DESCRIPTION
Click Configuration to specify which STP mode you want to activate. Click
MRSTP to edit MRSTP settings on the Switch.
Select which STP tree configuration you want to view.
Root refers to the base of the spanning tree (the root bridge). Our Bridge is this
Switch. This Switch may also be the root bridge.
This is the unique identifier for this bridge, consisting of bridge priority plus MAC
address. This ID is the same for Root and Our Bridge if the Switch is the root
switch.
This is the time interval (in seconds) at which the root switch transmits a
configuration message. The root bridge determines Hello Time, Max Age and
Forwarding Delay.
Chapter 11 Spanning Tree Protocol
for more information on
121