ZyXEL Communications ZyXEL Dimension ES-4124 User Manual page 318

Chapter 39 Cluster Management
Table 132 Management > Clustering Management > Configuration (continued)
LABEL
Apply
Cancel
Clustering
Candidate
List
Password
Add
Cancel
Refresh
The next summary table shows the information for the clustering members configured.
Index
MacAddr
Name
Model
Remove
Cancel
318
DESCRIPTION
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
The following fields relate to the switches that are potential cluster members.
A list of suitable candidates found by auto-discovery is shown here. The
switches must be directly connected. Directly connected switches that are set to
be cluster managers will not be visible in the Clustering Candidate list.
Switches that are not in the same management VLAN group will not be visible in
the Clustering Candidate list.
Each cluster member's password is its web configurator password. Select a
member in the Clustering Candidate list and then enter its web configurator
password. If that switch administrator changes the web configurator password
afterwards, then it cannot be managed from the Cluster Manager. Its Status is
displayed as Error in the Cluster Management Status screen and a warning
icon ( ) appears in the member summary list below.
If multiple devices have the same password then hold [SHIFT] and click those
switches to select them. Then enter their common web configurator password.
Click Add to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Refresh to perform auto-discovery again to list potential cluster members.
This is the index number of a cluster member switch.
This is the cluster member switch's hardware MAC address.
This is the cluster member switch's System Name.
This is the cluster member switch's model name.
Select this checkbox and then click the Remove button to remove a cluster
member switch from the cluster.
Click Cancel to begin configuring this screen afresh.
ES-4124 User's Guide