Activating Diffserv; Configuring 2-Rate 3 Color Marker Settings; Figure 142 Ip Application > Diffserv; Table 97 Ip Application > Diffserv - ZyXEL Communications ZyXEL Dimension ES-4124 User Manual

Chapter 32 Differentiated Services

32.3 Activating DiffServ

Activate DiffServ to apply marking rules or IEEE 802.1p priority mapping on the selected
port(s).
Click IP Application > DiffServ in the navigation panel to display the screen as shown.
Figure 142 IP Application > DiffServ
The following table describes the labels in this screen.
Table 97 IP Application > DiffServ
LABEL
Active
Port
*
Active
Apply
Cancel

32.3.1 Configuring 2-Rate 3 Color Marker Settings

Use this screen to configure TRTCM settings. Click the 2-rate 3 Color Marker link in the
DiffServ screen to display the screen as shown next.
258
DESCRIPTION
Select this option to enable DiffServ on the Switch.
This field displays the index number of a port on the Switch.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port
basis.
Note: Changes in this row are copied to all the ports as soon as you
make them.
Select Active to enable DiffServ on the port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Click Cancel to begin configuring this screen afresh.
ES-4124 User's Guide