Figure 190 Management > Syslog > Server Setup; Table 128 Management > Syslog > Server Setup - ZyXEL Communications ZyXEL Dimension ES-4124 User Manual

Figure 190 Management > Syslog > Server Setup
The following table describes the labels in this screen.
Table 128 Management > Syslog > Server Setup
LABEL
Active
Server Address
Log Level
Add
Cancel
Clear
Index
Active
IP Address
Log Level
Delete
Cancel
ES-4124 User's Guide
DESCRIPTION
Select this check box to have the device send logs to this syslog server. Clear the
check box if you want to create a syslog server entry but not have the device send
logs to it (you can edit the entry later).
Enter the IP address of the syslog server.
Select the severity level(s) of the logs that you want the device to send to this
syslog server. The lower the number, the more critical the logs are.
Click Add to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to return the fields to the factory defaults.
This is the index number of a syslog server entry. Click this number to edit the
entry.
This field displays Yes if the device is to send logs to the syslog server. No
displays if the device is not to send logs to the syslog server.
This field displays the IP address of the syslog server.
This field displays the severity level of the logs that the device is to send to this
syslog server.
Select an entry's Delete check box and click Delete to remove the entry.
Click Cancel to begin configuring this screen afresh.
Chapter 38 Syslog
311