ZyXEL Communications ZyXEL Dimension ES-4124 User Manual page 230

Chapter 26 Static Route
Table 82 IP Application > Static Routing (continued)
LABEL
Metric
Add
Cancel
Clear
Index
Active
Name
Destination
Address
Subnet Mask
Gateway
Address
Metric
Delete
Cancel
230
DESCRIPTION
The metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Enter a number that approximates the cost for this link. The number need
not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
Click Add to insert a new static route to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to set the above fields back to the factory defaults.
This field displays the index number of the route. Click a number to edit the static
route entry.
This field displays Yes when the static route is activated and NO when it is
deactivated.
This field displays the descriptive name for this route. This is for identification purpose
only.
This field displays the IP network address of the final destination.
This field displays the subnet mask for this destination.
This field displays the IP address of the gateway. The gateway is an immediate
neighbor of your Switch that will forward the packet to the destination.
This field displays the cost of transmission for routing purposes.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the Delete check boxes.
ES-4124 User's Guide