Authentication And Accounting Setup - ZyXEL Communications ZyXEL Dimension ES-4124 User Manual

Chapter 23 Authentication & Accounting
Table 62 Advanced Application > Auth and Acct > TACACS+ Server Setup (continued)
LABEL
Shared Secret
Delete
Apply
Cancel
Accounting
Server
Timeout
Index
IP Address
TCP Port
Shared Secret
Delete
Apply
Cancel

23.2.3 Authentication and Accounting Setup

Use this screen to configure authentication and accounting settings on the Switch. Click on the
Auth and Acct Setup link in the Authentication and Accounting screen to view the screen
as shown.
194
DESCRIPTION
Specify a password (up to 32 alphanumeric characters) as the key to be shared
between the external TACACS+ server and the Switch. This key is not sent over
the network. This key must be the same on the external TACACS+ server and the
Switch.
Check this box if you want to remove an existing TACACS+ server entry from the
Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
Use this section to configure your TACACS+ accounting settings.
Specify the amount of time in seconds that the Switch waits for an accounting
request response from the TACACS+ server.
This is a read-only number representing a TACACS+ accounting server entry.
Enter the IP address of an external TACACS+ accounting server in dotted decimal
notation.
The default port of a TACACS+ accounting server is 49. You need not change this
value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared
between the external TACACS+ accounting server and the Switch. This key is not
sent over the network. This key must be the same on the external TACACS+
accounting server and the Switch.
Check this box if you want to remove an existing TACACS+ accounting server entry
from the Switch. This entry is deleted when you click Apply.
Click Apply to save your changes to the Switch's run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the
top navigation panel to save your changes to the non-volatile memory when you
are done configuring.
Click Cancel to begin configuring this screen afresh.
ES-4124 User's Guide