Mitsubishi Electric NZ2GFCF-D62PD2 User Manual page 265

Remote input
Signal name
(RX) No.
Update flag
reset completed
(Latch count
value)
RX28 CH1
RX40 CH2
Update flag
reset completed
(Sampling
count value)
Update flag
reset completed
(Periodic pulse
count value)
• This signal turns on when resetting CH Update flag (Latch count value) (RX29, RX41) by
CH Update flag reset command (Latch count value) (RY28, RY40) is completed.
• This signal turns off when CH Update flag reset command (Latch count value) (RY28,
RY40) is turned off.
Controlled by the high-speed counter module
Controlled by the program
CH Update flag reset command
(Latch count value)
CH Update flag (Latch count value)
CH Update flag reset completed
(Latch count value)
• This signal turns on when resetting CH Update flag (Sampling count value) (RX29, RX41)
by CH Update flag reset command (Sampling count value) (RY28, RY40) is completed.
• This signal turns off when CH Update flag reset command (Sampling count value) (RY28,
RY40) is turned off. (The operation is the same as that of CH Update flag reset completed
(Latch count value) (RX28, RX40) except the signal name.)
• This signal turns on when resetting CH Update flag (Periodic pulse count value) (RX29,
RX41) by CH Update flag reset command (Periodic pulse count value) (RY28, RY40) is
completed.
• This signal turns off when CH Update flag reset command (Periodic pulse count value)
(RY28, RY40) is turned off. (The operation is the same as that of CH Update flag reset
completed (Latch count value) (RX28, RX40) except the signal name.)
Description
ON
(RY28, RY40) OFF
ON
(RX29, RX41)
OFF
ON
OFF
(RX28, RX40)
APPENDICES
A
263