Mitsubishi Electric NZ2GFCF-D62PD2 User Manual page 149

● When the latch counter function is performed by CH Function input terminal (FUNC1, FUNC2), the operation response
time follows CH Function input response time setting (address: 0129
count value (RWr12 to RWr13, RWr2A to RWr2B) is updated synchronizing with the internal control cycle, a maximum of
delay time shown below occurs until the acquired value is stored.
*1
• T
+ Setting time of CH Function input response time setting (address: 0129
1
For T
*1 , refer to Page 305, Appendix 4.
1
● The latch counter function cannot be performed while CH Selected counter function start command (RY25, RY3D) or
CH Function input terminal (FUNC1, FUNC2) is on even if the other is turned on.
CHAPTER 8 FUNCTIONS
.b2 to b3, 0149 .b2 to b3)). Since CH Latch
H H
.b2 to b3, 0149
H
.b2 to b3)
H
8
147