Mitsubishi Electric NZ2GFCF-D62PD2 User Manual page 242

*11 Stops measuring pulses.
*12 Does not output the PWM waveform.
*13 Stops operations except the one on the error. The updating EQU1 to EQU4 terminal status (RWr1), Cam switch output
signal (RWr2), Cam switch output terminal status (RWr3), CH Status (RWr20, RWr38), and CH External input status
(RWr21, RWr39) is stopped.
*14 Continues its operation although the external output terminals of the extension output module are forced off. (Y0 LED to
YF LED on the extension output module turn on or off depending on the output status.)
*15 A minor error which can be reset by turning off then on CH Error reset command (RY36, RY4E)
*16 Stores 0 in all the monitor data and keeps 0 until the module operation information is initialized. The number of ON times
integration does not start.
*17 The module operates according to a value set in Mode switch setting (address: 0000
turned off and on or at remote reset.
*18 Mode switch setting change (error code: 0190
During the error, the high-speed counter module keeps operating in the mode before Mode switch setting (address:
0000 ) change. To reset the error in the previous mode, set the previous value to Mode switch setting (address: 0000
H
and turn on and off Initial data setting request flag (RY9).
*19 The CC-Link IE Field Network synchronous communication function stops working.
240
) is not reset even if five seconds have passed after the error occurred.
H
) when module power supply is
H
)
H