Mitsubishi Electric NZ2GFCF-D62PD2 User Manual page 261

Remote input
Signal name
(RX) No.
RXA Error status flag
RXB Remote READY
RX10 Coincidence output 1
RX11 Coincidence output 2
RX12 Coincidence output 3
RX13 Coincidence output 4
• This signal turns on when CH Error status (RX36, RX4E) turns on.
• This signal turns off when CH Error status (RX36, RX4E) turns off.
Controlled by the high-speed counter module
Controlled by the program
CH1 Error reset command
(RY36)
Remote READY
(RXB)
CH1 Latest error code
(RWr22)
CH1 Error status
(RX36)
CH2 Error status
(RX4E)
Error status flag
(RXA)
• This signal turns on when the initial data setting processing is completed after the module is
powered on or the remote reset is performed.
• This signal turns on after Initial data processing request flag (RX8) turns off.
• This signal turns on when Initial data processing request flag (RX8) is off and Initial data
setting completion flag (RX9) is turned off.
• This signal turns off when Error status flag (RXA) turns on.
• This signal can be used as an interlock of programs. (For the overview of the operation, refer
to the descriptions of Initial data processing request flag (RX8), Initial data setting
completion flag (RX9), and Error status flag (RXA).)
• This signal turns on when the comparison condition of CH Present value (RWr10 to
RWr11, RWr28 to RWr29) is satisfied in the coincidence output function. (For details of the
ON/OFF conditions of this signal, refer to Page 116, Section 8.5.2.)
• The ON condition can be changed with Coincidence output comparison condition setting
(address: 0102 ).
H
For within-range output operation
Ex.
Controlled by the high-speed counter module
Point setting (Coincidence output 1 to 4)/
Lower limit value setting
(Coincidence output 1 to 4)
(RWw0 to RWw1, RWw4 to RWw5,
RWw8 to RWw9, RWwC to RWwD)
Upper limit value setting
(Coincidence output 1 to 4)
(RWw2 to RWw3, RWw6 to RWw7,
RWwA to RWwB, RWwE to RWwF)
Coincidence output 1 to 4
(RX10 to RX13)
CH Present value
(RWr10 to RWr11, RWr28 to RWr29)
*2
• Up to T
delay occurs until this signal turns on after the comparison conditions of CH
1
Present value (RWr10 to RWr11, RWr28 to RWr29) are satisfied in the coincidence output
function.
Description
ON
OFF
ON
OFF
0 1200
H
ON
OFF
ON
OFF
ON
OFF
ON
OFF
0 1 999 1000
APPENDICES
ON
0
1000
2000
2000 2001
259
A