Table of Contents
Advertisement
1. MOUNTING
Other compatible transducers (local supply)
The transducers (Manufactured by AIRMAR Technology Corporation) listed in the ta-
ble below are compatible with this equipment.
Single Frequency CHIRP
Output Power
300W
600W
1kw (FCV-800 only)
Dual Frequency CHIRP
Output Power
1kw (FCV-800 only)
1.2
Main Unit
This unit can be mounted on a desktop, bulkhead or flush mounted in a console.
Mounting considerations
When choosing a location keep the following in mind:
• Do not overhead mount the unit.
• Select a location where the unit is easy to operate.
• Be sure to follow the recommended maintenance space show in the outline draw-
ing.
• Locate the unit away from the air from air conditioners.
• The operating temperature range is 5°F to 131°F.
• Locate the unit away from devices that emit active gas.
• The mounting location must be well ventilated.
• Select a location where vibration and shock are minimal.
• A magnetic compass will be affected if the main unit is placed too close to the com-
pass. Observe the compass safe distances in the safety instructions (see page i) to
prevent interference to the compass.
• Select a location out of direct sunlight. Prolonged exposure to direct sunlight can
cause LCD blackout.
• When installing the sub monitor, select a location where wireless LAN icon (at least
two bars) is shown in the upper right corner of the sub monitor's display.
B150M
SS75L
B75M
SS75M
B175M
TM185M
B265LM TM265LM CM265LM
Type
B785M
SS75H
B285M
B175HW
Type
B275LHW
3
TM165HW
TM185HW
B285HW
TM275LHW CM275LHW
Advertisement
Table of Contents
