Table of Contents
Advertisement
3. INITIAL SETTINGS
is not shown on the list in step 3, depending on the transmission output, select
[600W] or [1kW] (for FCV-800 only).
Note 1: Make sure to select the appropriate transducer. Otherwise the connected
transducer will be damaged.
Note 2: You can view and modify transducer settings on the [Transducer] menu
from the [System] menu (see Operator's Manual for further information).
5. If the transducer is connected to [XDR2] port, select [XDR2 Type] on the menu
and select the appropriate transducer (for FCV-800 only).
6. Press the MENU/ESC key to close the menu. ''Restart to apply changes?'' mes-
sage appears.
7. Select [Yes] and press the KNOB to finish.
3.2
Input/Output Settings
This section describes how to adjust input/output data settings.
3.2.1
Data source settings
On the [Data Source] setting window, select the desired sensor for SOG, STW, Nav
Data, Heading, Position, Wind Spd/Dir, Atmos Press. (Atmospheric Pressure), Water
Temperature and heave.
1. Turn on the power of all the connected sensors.
2. Press the MENU/ESC key to show the main menu.
3. Select [Network] from the [System] menu, then press the KNOB.
Example of FCV-800 dispay
29
Advertisement
Table of Contents
