Calibration Settings - Furuno FCV-600 Installation Manual

3. INITIAL SETTINGS
3.3.2 LAN settings on the sub monitor side
Do the following procedure when using the FCV as a sub monitor.
1. Press the MENU/ESC key to show the main menu.
2. Select [Network] and press the KNOB.
3. Select [Wireless LAN] and press the KNOB.
4. Select [Wireless LAN Setting] and press the KNOB.
5. Select [Wireless LAN] and press the KNOB.
6. Select [On] and press the KNOB.
7. Select [Mode] and press the KNOB.
8. Select [Sub] and press the KNOB.
9. Check that the [Wireless Mode] is set as [Client Mode].
Note: The main monitor and sub monitor should use the same network.
10. Continue from the page 35 step 11 to finish.
Note: Check the wireless LAN icon (bar) in the upper right corner of the sub mon-
itor display. A Location with two or more bars are recommended for installation.
3.3.3 LAN settings on the iOS or Android™ device
If you are using an iOS device or Android™, carry out the following settings.
• Network name set for the FCV main unit
• Password of the network set for the FCV main unit.
Note: The FCV and the iOS /Android™ should be connected on the same network.
3.4

Calibration settings

1. Press the MENU/ESC key to show the main menu.
2. Select [Calib] and press the KNOB.
Example of FCV-800 display
39