Table of Contents
Advertisement
6. Rotate the butterfly bolts and butterfly nuts attached to the flush mount F metal
(two in total) to move the screw leg protector towards the mount F metal.
Mount F metal assembly
Note: Tighten the butterfly bolts by
hand without using tools. When
tightening the bolts, tighten the all
four bolts evenly and gradually.
Tools can be used for tightening the
butterfly nuts.
7. Use both slotted hex bolts (M612,
supplied) and fasten mount F metal assembly to the both sides of the main unit.
F Mount metal assembly should be attached to the hanger mounting screw holes
on both sides of the main unit.
8. Rotate the butterfly bolts of the mount F metal to fasten the screw leg protector to
the panel.
9. Fasten the butterfly nuts of the mount F metal.
10. Attach the hard cover to the unit for LCD protection.
Mount F metal
Move towards flush mount F metal
Screw holes for hanger mounting
Butterfly bolt
Butterfly nut
F mount metal
Screw leg protector
Panel
Monitor unit
6
Butterfly bolt (see the Note below).
Butterfly nut
Screw leg protector
F Mount metal assembly
Slotted hex bolt
Panel
1. MOUNTING
Advertisement
Table of Contents
