Table of Contents
Advertisement
5. Using the vertical adjustment space
on the bracket slots, slide the sensor
up or down to provide a projection of
3 mm (1/8").
6. Tighten the self tapping screws.
Attaching the sensor to the bracket
1. If the retaining cover near the top of the
bracket is closed, open it by depressing the
latch and rotating the cover downward.
2. Insert the sensor's pivot arms into the slots
near the top of the bracket.
3. Maintain pressure until the pivot arms click
into place.
4. Rotate the sensor downward until the bot-
tom snaps into the bracket.
5. Close the retaining cover to prevent the ac-
cidental release of the sensor when the boat
is underway.
Cable routing
Route the sensor cable over the transom, through a drain hole, or thorough a new hole
drilled in the transom above the waterline. If a hole must be drilled, choose a location
well above the waterline. Check for obstructions such as trim tabs, pumps, or wiring
inside the hull. Mark the location with a pencil. Drill a hole through the transom using
a 19 mm or 3/4" bit (to accommodate the connector).
Note: Never cut the cable or remove the connector; this will void the warranty. Always
wear safety goggles and a dust mask.
1. Route the cable over or through the transom. On the outside of the hull secure the
cable against the transom using the cable clamps. Position a cable clamp 50 mm
(2") above the bracket and mark the mounting hole with a pencil.
2. Position the second cable clamp halfway between the first clamp and the cable
hole. Mark this mounting hole.
3. If a hole has been drilled in the transom, open the appropriate slot in the transom
cable cover. Position the cover over the cable where it enters the hull. Mark the
two mounting holes.
4. At each of the marked locations, use a 3 mm or 1/8" bit to drill a hole 10 mm
(3/8") deep. The prevent drilling too deeply, wrap masking tape around the bit 10
mm (3/8") from the point.
Step 1
Retaining
cover
18
1. MOUNTING
Cable cover
Cable
clamp
50 mm (2")
Hull projection
3 mm (1/8")
3 mm
Step 2
Latch
Pivot
arm (2)
Slot (2)
Step 3
Step 4
Advertisement
Table of Contents
