Table of Contents
Advertisement
4. Select [Data Source] and press the KNOB. [Data Source] setting window will be
shown.
5. Select the desired data and press the KNOB.
Selection window for data source will be
shown. The example display on the right is
shown when [SOG] is selected.
6. Select one of the following data sources and
press the KNOB. The choices displayed in the
[Data Source] selection window depend on
the item selected in step 5.
• [---------]: Unselected
• [Port 1] (for FCV-800 only): Data is imported from NMEA0183 device connect-
ed to the [PWR/KP/NMEA0183] port.
• [Own], [Own1] (for FCV-800 only): Data is imported from transducer connect-
ed to the [XDR] (for FCV-600) or [XDR1] (for FCV-800) port.
• [Own2] (for FCV-800 only): Data is imported from transducer connected to
[XDR2] port.
• NMEA2000/CAN ID: Data is imported from NMEA2000 device connected to
[NMEA2000] port. If multiple devices are connected to the same network, the
names of all devices are displayed. Select the desired device for data source.
7. Repeat step 5 to step 6 and set all data sources.
8. Press the MENU/ESC key twice to close the menu.
NMEA2000 decive name
30
3. INITIAL SETTINGS
Port1
PG-700: 0026844
CAN specified ID
Example of FCV-800 display
Advertisement
Table of Contents
