Table of Contents
Advertisement
6. Select [Heave Sensor Position (SC)] and press the KNOB.
STERN
7. See the figure above to enter the Satellite Compass™ location information. Set
the Satellite Compass™ position ([Bow/Stern] [Up/Down] [Port/Starboard]) as
measured from the standard point ("0"). Port is "-" and starboard is "+".
8. If the seabed is not displayed stably even when position is set correctly, select
[Heave Sensor Delay] and press the KNOB.
9. Set the delay value and press the KNOB.
Recommended setting value is 10ms. See the window when adjusting the value.
10. Press the MENU/ESC key to return to the [Heave Sensor Setting] window.
11. Select [XDR Position] (FCV-600) or [XDR1 Position] (FCV-800) and press the
KNOB.
STERN
12. See the figure above to enter the location information of the transducer connected
to the [XDR] (FCV-600) or [XDR1] (FCV-800) port. Set the position of the trans-
ducer ([Bow/Stern] [Up/Down] [Port/Starboard]) as measured from the reference
point ("0"). Port is "-" and starboard is "+".
If you have a transducer connected to the [XDR2] (FCV-800) port, carry out
[XDR2 Position] setting procedure same as explained above.
13. Press the MENU/ESC key twice to close the menu.
TM
SC: Satellite Compass
Up/Down: Height of the Satellite Compass
(Standard point: Ship bottom)
Bow/Stern: Bow and stern direction of the
Satellite Compass
Port/STBD: Left/right direction of the Satellite Compass
(Standard point: Ship centerline)
TD: Transducer
Up/Down: Height of the transducer
42
3. INITIAL SETTINGS
TM
TM
(Standard point: bow)
TM
Advertisement
Table of Contents
