Table of Contents
Advertisement
SAFETY INSTRUCTIONS
The operator and installer must read the applicable safety instructions before attempting to
operate or install the equipment.
WARNING
CAUTION
Warning, Caution
Safety Instructions for the Installer
WARNING
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Be sure no water leaks in at the
transducer or sensor mounting
location.
Water leakage can sink the vessel. Also
confirm that the transducer and/or
sensor will not loosen by ship's vibration.
The installer is solely responsible for the
proper installation of the equipment.
FURUNO will assume no responsibility
for any damage associated with
improper installation of the transducer.
Use the specified power cable.
Use of other power cable can cause fire.
CAUTION
Do not install the transducer or sensor
where air bubbles and noise are
present.
Performance will be affected.
Indicates a condition that can cause death or serious injury
if not avoided.
Indicates a condition that can cause minor or moderate
injury if not avoided.
Prohibitive Action
The following are guidelines for
handling of the transducer cable.
- Keep fuels and oils away from the
- Locate cable in a safe place.
- Do not paint the cable.
The sheath of the cable is made of
chloroprene rubber (or polychloride
vinyl). For this reason do not paint the
cable.
Do not turn on the equipment with the
transducer out of water.
The transducer can be damaged.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
FCV-800
i
Mandatory Action
CAUTION
cable.
Standard
Model
compass
FCV-600
0.40m
0.70m
Steering
compass
0.30m
0.45m
Advertisement
Table of Contents
