Table of Contents
Advertisement
3. INITIAL SETTINGS
4. Select [Wireless LAN Setting] and press the KNOB.
5. Select [Wireless LAN] and press the KNOB.
6. Select [On] and press the KNOB.
7. Select [Mode] and press the KNOB.
8. Select [Master] and press the KNOB.
9. Select [Wireless Mode] and press the KNOB.
10. Select one of the following settings and press the KNOB.
• [AP Mode]: Use the FCV main unit (main monitor) as an access point.
• [Client Mode]: Use existing access point.
11. Press the MENU/ESC key.
The confirmation message ''Restart to apply changes?'' appears.
12. Select [Yes] and press the KNOB.
The system restarts. After restarting, if you selected "AP Mode" in step 10, a wire-
less LAN icon (
indicates that the FCV is used as an access point.
13. Repeat step 1 to 3 to show the [Wireless LAN] setting window.
14. Depending on the item selected in step 10, do one of the following procedures.
For [AP Mode]
1) Select [Local Network Setting] on the [Wireless LAN] menu.
2) To change the network name (factory default: the model name of the unit), select
[Network Name] and press the KNOB.
[Network Name] display will be shown. If no changes are required, go to step 4.
) will appear in the upper right corner of the screen. This icon
Example of FCV-800 display
35
Advertisement
Table of Contents
