1. MOUNTING
5. Apply marine sealant to the threads of the #6 x 1/2" self-tapping screw to prevent
water from seeping into the transom. If you have drilled a hole through the tran-
som, apply marine sealant to the space around the cable where it passes through
the transom.
6. Position the two cable clamps and fasten them in place. If used, push the cable
cover over the cable and screw it in place.
7. Route the cable to the instrument being careful not to tear the cable jacket when
passing it though the bulkhead(s) and other parts of the boat. To reduce electrical
interference, separate the sensor cable from other electrical wiring and "noise"
sources. Coil any excess cable and secure it in place with zip-ties to prevent dam-
age.
19