Safety Instructions - Furuno FCV-1900/B/G Installation Manual

SAFETY INSTRUCTIONS

The installer must read the appropriate safety instructions before attempting to install the equip-
ment.
WARNING
CAUTION CAUTIO
Warning, Caution
WARNING
ELECTORICAL SHOCK HAZARD
Do not open the equipment unless
totally familiar with electrical circuits
and service manual.
Only qualified personnel are allowed
work inside the equipment.
Turn off the power at the switchboard
before beginning the installation.
Fire or electrical shock can result if the
power is left on.
Do not install the equipment where it
may get wet from rain or water splash.
Water in the equipment can result in fire,
electrical shock or damage the equip-
ment.
Be sure no water leaks in at the
transducer mounting location.
Water leacage can sink the vessel. Also,
confirm that the transducer will not loosen
by ship's vibration. The installer of the
equipment is solely responsible for the
proper installation of the equipment.
FURUNO will assume no responsibility
for any damage associated with improper
installation.
Use the proper cable and fuse.
Use of an incorrect cable and fuse can
damage the equipment and cause fire.
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided,
could result in minor or moderate injury.
Prohibitive Action
i
Mandatory Action
CAUTION CAUTIO
Ground the equipment to prevent
mutual interference.
Do not transmit with the transducer
out of water.
The transducer may become damaged.
Do not allow warm water or any other
liquid other than sea water or fresh
water to contact the transducer.
Damage to the transducer may result.
Observe the following compass safe
distance to prevent interference to a
magnetic compass:
Standard
compass compass
FCV-1901 1.00 m
FCV-1902 0.60 m
FCV-1903 0.70 m
The transducer cable must handled
carefully, following the guidelines
below.
- Keep fuels and oils away from the
cable.
- Locate the cable where it will not be
dameged.
The cable sheeth is made of chloro-
phrane or polychloride vynil, which are
easily dameged by plastic solvents such
as toluene. Locate the cables away from
plastic solvents.
Steering
0.60 m
0.35 m
0.45 m