Table of Contents
Advertisement
80A Charging Station Series 2
5.4. Charging an Electric Vehicle (EV)
Choices of start charging are as below:
5.4.1. Operation for Charger as Shipped (Plug and Charge)
1.
Insert the charging plug into the EV
2.
Charging session started
Figure 5.1 Connect the Charging Plug to the EV
or
5.4.2. If RFID Access Control is enabled on your charger, then you
will authorize charge session by RFID Card (Authorize first and
then plug)
1.
Swipe card
2.
Wait until the screen changes to "authorizing"
3.
Insert the charging plug into the EV. Session will timeout after 60s
4.
Charging session started
5.5. Stop Charging
1.
Unplug any time (disconnect the charging plug from EV to stop charging
session)
2.
Session ended (return the connector to the holster)
28
Installation Manual
Advertisement
Table of Contents
