Turning Off The Projector - Christie Mirage SST-6P User Manual

The projector can also be turned on using the web user interface. After a few seconds, the
projector moves to the on state, causing the yellow light on the laser illumination source to
turn off. The laser is ready to be turned on but no illumination occurs until the green button is
pressed and the lasers have warmed up.
6. Turn on the lasers:
• Local operation and the J33 terminal block 1 installed— On the laser illumination source,
press the green Start button (D). This illuminates the green (button) light and the yellow
light goes out.
• Remote operation and the J33 terminal block 2 installed—From the automation device,
turn on the lasers with a 500ms contact closure of circuits 21/22 on the J33 wire. This
illuminates the green (button) light and the yellow light goes out.
The two Emission status indicators (E) turn red. When the lasers are warmed up and the
projector is ready, the shutter automatically opens and you can display an image (use test
pattern if no source image is connected).
On the projector, the Status > Laser Info > Laser Bank State menu displays the message
"Warming Up". When that message disappears, the lasers are ready. It typically takes the
lasers approximately 10 to 15 minutes to warm up when turning on the first time from the off
position. This could be longer if the start-up temperatures are approaching minimum or
maximum temperatures for operation. The projector will operate with the shutter closed until
the lasers are warmed up.

Turning off the projector

When powering off in preparation for inspection or maintenance, always disconnect from AC.
1. To turn the light source off using the projector keypad, press and hold the
hear a beep.
To turn off the light source using the remote, press and hold the OFF button until you hear a
beep.
When powering off the projector, allow the projector to complete its cool down cycle. Do not
immediately unplug the projector if this can be avoided.
2. To turn off power to the projector, disconnect from AC power.
Mirage SST User Guide
020-102993-06 Rev. 1 (10-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Operating the projector
button until you
21