Table of Contents
Advertisement
1
Fig. – Wheel
1.
Nuts
3
2
1
6
Fig. – Air filter
1. Clamps
2. Cover
3. Main filter
4. Safety filter
5. Filter case
6. Dust valve
Fig.
Inside of the
Outlet tube
72
Check the tightness of the wheel nuts
Confirm the tightening torque of the REAR wheel nuts (1) with
770 Nm (78kpm) / 550 Nm (56 kpm) and FRONT wheel with
494 Nm (50 kpm):
Check all wheels and all nuts (this information is valid only for
new machines or newly installed wheels).
Check and clean the engine air filter elements
1.
Loosen the clamps (1); remove cover (2) and the main filter
(3). Do not remove the safety filter
2.
Clean the air filter, if necessary, following the instructions on
this
3.
When replacing the main filter (3), insert a new one in its
place and fit the air filter components in the reverse
4
5
4.
Verify that the anti -dust valve (6) is in good condition and
replace if
5.
When attaching the cover, make sure that the anti -dust
valve is facing
To carry out the air filter cleaning, follow the instructions
1.
Clean the inside of the cover and filter
2.
picture.
Outside of the
Outlet tube
4812325556EN
Scheduled maintenance
Replace the main filter element when the
corresponding warning light is illuminated on the
instrument panel when the engine is at full
page.
necessary.
down.
Replace the secondary air filter every five main air
filter
uses.
Also clean the surfaces of the outlet tube, as shown in the
Check that the hose clamps between the filter
housing and the intake hose are tight and that the
hoses are intact. Check all hoses system until the
engine.
speed.
(4).
order.
below:
housing.
08/01/2023
Advertisement
Table of Contents
