Table of Contents
Advertisement
3
Fig. – Side panel
1.
Display
2.
Brake test button
3.
Parking brake
4.
Forward and reverse control
46
Dynamic Brake Test
1
The dynamic brake test must be done with parking
brake switch button (3) released. Press the brake test
button (2) the accumulators will start to fill and a sound
2
effect will activate on the machine and the test button
light will begin to flash (the sound effect and flash in test
button occurs until the accumulator reaches 90 bars -
1305 Psi). After that, the led from the test button will
stay on and the alarm will stop. Move the joystick (4)
4
slowly to the maximum position forward or reverse. The
engine goes to maximum rpm by itself.
During the test, the system automatically will change to
transport mode. See in Display (1).
After the test, enable the parking brake or press again
the brake test button to end the Dynamic Brake test
mode. When the test ends, the system will reduce
engine rpm automatically and change to previous
selected mode (work or transport).
4812325556EN
NOTE: Make sure to perform the test in an
open place away from physical barriers, as in
case of any unforeseen event and the machine
move, no accident will occur.
In case the machine speed goes higher than
1km/h within 3 seconds while executing the
dynamic or parking brake test, the roller will
automatically enter "Safe Mode".
The machine should be stopped and the
representative must be called immediately.
Operation
08/01/2023
Advertisement
Table of Contents
