Table of Contents
Advertisement
Fig. – Fuel tank
1. Filling cap
2
Fig. – Fuel tank draining
2. Plug
1
Fig. - Water tank
1. Water filter
08/01/2023
4. Unscrew the hexagon nut, remove the hose and unscrew
the drain plug. Drain all the fluid to the container.
5. After the replacement, tighten the drain plug and fit back
the hose and the hexagon nut.
Empty and clean the fuel tank
NEVER perform maintenance work under the
machine when the engine is working. Always park
the roller on a flat and safe place and chock the
tires.
The fastest and simple way to clean the tank is when it is empty:
1. Open the filling cap (1) of fuel tank.
2. Place two proper containers under the drain plug of the fuel
tank (2).
The drain plug of the fuel tank is on the right side of
the machine, in a proper compartment.
3. Unscrew the drain plug (2) and drain the remaining fuel
inside the tank.
4. Refit the drain plug and tighten it.
Using adulterated, contaminated, dirty or bad
quality fuel damages the injection system and
engine components. The repairs due the conditions
above are NOT covered by the warranty.
TAKE CARE OF THE ENVIRONMENT: All the used
waste shall be properly stored for subsequent
recycling. Do not dispose of any waste on the
ground, sewage system or other place which can
harm the environment.
Be extremely careful when handling fuel. There
is risk of fire.
Empty and clean the water tank
Wash the water tank adding a small quantity of a suitable
detergent for plastic surfaces.
Remove the water filter to empty the tank.
The
water
(polyethylene) and can be recycled.
4812325556EN
Revision History
tank
is
made
of
plastic
77
Advertisement
Table of Contents
