Fayat Group CP1200 Instruction Manual page 74

Fig. – Fuel tank
1. Tank cover
2. Filling pipe
Fig. – Dust ejection valve
70
Fill the fuel tank
Never fill the engine when it is working. Do not
smoke and avoid spilling fuel.
The supply nozzle and the reservoir cap are located in front of
the operator platform on the left side of the
Check the fuel tank every day before starting work, or fill the
tank when the work is
Loosen and remove the fuel cap (1) and make the check to the
oil fill.
The tank has a capacity of 215 liters of fuel. For more
information about the quality of fuel, see engine
When refueling, stop the machine on a level and
secure, turn off the engine and ground the
supply nozzle placing it in contact with the
chassis not isolated spot, before the start filling.
While refueling, hold the pump nozzle in contact
with the oil fill tube. Always fill with fuel
recommended by Dynapac.
The use of adulterated fuel, contaminated, dirty or
poor quality, damages the components of the
injection and engine system. Repairs under this
condition are NOT covered under warranty.
Clean the dust ejection valve (Tier IV)
Clean the valve eject dust filter air daily after working hours ,
pressing the valve and letting the dust out while
After leaving all the dust, release the
Refer to the Engine Operation Manual and maintenance
for more information.
4812325556EN
Scheduled maintenance
machine.
completed.
valve.
manual.
open.
08/01/2023