GE MAC 5 A4 Operator's Manual page 322

Configure the MUSE System for Network Communication
13. In the End Point Configuration area of the window, select the protocol(s) you are
using to communicate with MUSEAPI3 and enter the port value(s).
You must have at least one protocol enabled, and you may have more than one.
If any protocols are selected that you do not want, remove the check mark.
You are advised to use the values below for the ports:
Protocol
HTTP
HTTPS
net.tcp
NOTE:
14. Determine whether you want to check the box next to PID Search: Combined
Test Lists to change the Patient Conflict behavior of the MUSEAPI3 and do one of
the steps below:
• Select to enable the PID Search: Combined Test List. When performing
• To disable the PID Search: Combined Test List, leave the box unselected.
This setting can always be changed later.
NOTE:
322
For more information on the available communication protocols, see
116: MUSEAPI3 Installation Prerequisites on page
a Patient ID search while this option is enabled, MUSEAPI3 automatically
combines all tests for that Patient ID for the same MUSE site, even if there is a
Patient ID/Last Name mismatch.
When performing a Patient ID search while this option is disabled, MUSEAPI3
includes patient conflicts if there is a Patient ID/Last Name mismatch within
the same site.
MUSEAPI v3.1 handles patient conflicts within the same MUSE site differently
than MUSEAPI v3.0. MUSEAPI v3.1 only provides a response that includes
MAC ™ 5 A4/MAC ™
Recommended Port Values
8100
The port for SSL, as configured by the customer.
8101
5 A5/MAC ™ 5 Lite
Table
312.
5864335-001-1