Table of Contents
Advertisement
b)
c)
d)
e)
f)
2.
Expand the Certificates node in the left panel.
3.
Expand the Personal node in the left panel and click the Certificates node.
The certificate that the customer obtained and installed is listed here.
4.
Double-click on the certificate the customer obtained and installed to open it.
5.
Select the Details tab.
6.
In the list box, click Thumbprint.
The bottom window lists the hex values.
7.
Select and copy the list of hex values from step
Notepad.
8.
Remove all the spaces between the values to make one long string.
When you are done, it will look similar to the code below:
a237052b1a2d52f72c576c5702136802a7bf8804
This is your certificate thumbprint.
9.
Use Run as Administrator to obtain a command-prompt, then run the two
commands below:
• netsh http add sslcert ipport=0.0.0.0:(port assigned
• netsh http add sslcert ipport=[::]:(port assigned
10. Run the command below to show the SSL Certificate bindings and verify that the
IP:port, Certificate Hash, and Application ID match those entered in step 9:
5864335-001-1
When the Microsoft Management Console (MMC) opens, press Ctrl+M to
add a snap-in.
In the Add or Remove Snap-ins dialog box, do the steps below:
1.
In the Available snap-ins list, select Certificates.
2.
Click Add.
In the Certificates snap-in dialog box do the steps below:
1.
Select Computer account.
2.
Click Next.
Select Local computer and click Finish.
To close the Add or Remove Snap-ins dialog box, click OK.
for MUSEAPI3 HTTPS protocol goes here) certhash=[your
thumbprint] appid={3df9aba0-cbd8-4dbe-b3c7-
daf47b8a015b}
for MUSEAPI3 HTTPS protocol goes here) certhash=[your
thumbprint] appid={3df9aba0-cbd8-4dbe-b3c7-
daf47b8a015b}
MAC
™
Configure the MUSE System for Network Communication
6
5 A4/MAC
™
5 A5/MAC
™
5 Lite
into a text editor such as
327
Advertisement
Table of Contents
