Table of Contents
Advertisement
NOTE:
WARNING:
7.6 Software Update
Update the receiver via USB or OTA (download via satellite). If these updates are available, then they will
be executed by pressing OK.
7.6.1 USB Update
This function allows you to perform a software update with a USB storage device.
Download the software and update instructions from our website www.strong.tv and unzip it on your
PC. Then load the file to the root directory of your correctly formatted USB storage device and connect it
to your receiver. Turn on the receiver and wait until the USB device is successfully detected.
Press OK in the menu USB Update and confirm the displayed message, then wait until the software
updates and loading process begins. After the loading process has been started successfully (a progress
banner is displayed) you can disconnect the USB storage device (or wait until the update is fully loaded)!
Please disconnect the USB device after a successful update in order to restart the receiver!
WARNING:
NOTE:
7.6.2 OTA Software Update
The OTA (Over the Air) function check automatically if software updates available on satellite. Please ask
your local STRONG dealer or visit our website www.strong.tv for information.
24
For watching a certain movie the receiver will request entering of the
maturity rating PIN code. You can create up to 6 different profiles which can
also be deleted again. Whenever a profile for a specific age is going to be
set, please consider that the PIN code for this age is generated for this age
only and should be noted by an adult person. Generally, you can use the
Master PIN for every age restriction and by entering it you can also check
the PIN for the different maturity rating groups.
The maturity rating function might have influence on the timer recording
behaviour if the maturity rate for a programmed event differs to the rate of
a previous movie. This will lead to a new PIN enter request or the receiver
enters the auto standby mode in the meantime and so also requests
the PIN. The master PIN of your smartcard can only be changed via the
broadcaster.
NEVER disconnect the receiver from the mains or switch the power OFF
during the update procedure. It can damage your receiver and warranty will
be void! In case of an USB software update please consider that the receiver
may delete all channels, data and user settings in certain cases.
The above mentioned USB functions require a correctly formatted USB
storage device to be connected to the receiver.
Advertisement
Table of Contents
