Table of Contents
Advertisement
7.3 Settings
Use the Settings menu to configure settings for background functions, audio, video, look and feel of your
receiver. Choose a setting with pq and press OK to list the possibilities or use t u to change the value
of the highlighted setting. Please also read the displayed instructions for each screen carefully. They will
help you to adjust the settings correctly and easily.
7.3.1 System Settings
Auto PMT Monitor:
Auto NIT Monitor:
Auto Standby:
S/PDIF Audio Output:
HDMI Audio Output:
Standby After Record:
Program List Display:
OTA In standby Active:
Dolby Audio First
Press to leave the System Settings menu.
7.3.2 Display
In this submenu Display Settings you can setup which screen type you have connected and how the best
way it is shown. The following parameters can you adjust:
Resolution
Aspect Ratio
Aspect Conversion
Transparency
Banner Time
18
Auto Program Mapping Table means, if set to On it can switch automatically
to local area channels when those start broadcasting. Depending on
broadcaster.
Auto Network Information Table means, If set to On it will update channels
automatically to the network. Depending on broadcaster.
This function is a new power saving feature that helps reducing power
consumption. It switches the receiver to standby when no command has
been received from the remote control for at least the set time. Possible
settings are: 1H- 6H and OFF to deactivate.
Toggles between PCM and RAW (Bitstream) output. When PCM is selected, all
digital audio will be converted to stereo audio. RAW enables you to listen or
transfer Dolby® Digital/Dolby® audio to a home cinema set through coaxial S/
PDIF. (Not Dolby® Digital Plus)
Toggles between PCM and RAW (Bitstream) output. When PCM is selected, all
digital audio will be converted to stereo audio. RAW enables you to listen or
transfer Dolby® Digital/Dolby® Digital Plus* audio to the TV via HDMI or to a
home cinema set.
This function allows you to determine whether the receiver should switch to
standby after the end of the programmed timer(s) On, or whether the receiver
should remain switched on Off.
Choose between Advanced for program list with3 rows with 47 channels or
Simple Programme list with 1 row with 10 channels and sort functions.
Select a time after the receiver went to standby mode, to check if there is new
software available on air.
Set to On if you would like to choose Dolby audio only if available on a
channel.
576i, 576p, 720p, 1080i or 1080p, to adjust the optimum resolution your TV set
supports.
Auto, 16:9 or 4:3, depending on the type of your TV screen.
Pan Scan, Letterbox, Pillar Box or Full Screen, to choose the preferred picture
format.
Make the live TV video visible below the menu and information banner.
Select the time-out of the information banner.
Advertisement
Table of Contents
