Table of Contents
Advertisement
WARNING:
„ Do not take any action during the update procedure if the receiver has not restarted yet or if an error
message appears.
„ Do not disconnect the receiver from the mains nor switch o until the software update
has been completed.
7.4.8 OTA upgrade (manual)
This submenu allows to update your receiver with last improved software version trough air from satellite
signal. OTA = (Over The Air). Normally will the receiver detect automatically if software is availeble. In some
cases, will be software availeble on other frequencies / transponders when there technical need to change
automatic way. The needed information where this is broadcasted will be availeble on our website or you
can nd out via your local support or dealer whether there is a new software version broadcasted.
Satellite name:
Transponder:
Download PID:
Press RED to start the OTA upgrade procedure.
WARNING:
„ Do not take any action during the update procedure if the receiver has not restarted yet or if an error
message appears.
„ Do not disconnect the receiver from the mains nor switch o until the software update
has been completed.
7.4.9 Software Update (OTA)
Your receiver can automatically update the software via digital broadcast.
If a new software is availeble, the new version will be shown on screen as message.Con rm to start the
updating procedure from the broadcasting signal.
NOTE:
If the operator forces the software update procedure while you are watching TV or radio
channels, the receiver can automatically switch to update mode.
During software update procedure the receiver will enter the update mode and will show the Software
update screen, which contains information about your current and new software versions and further
reference details. During update procedure the progress bar will inform you about the remaining time. After
nishing the software update, the receiver will reboot automatically and tune to the last viewed channel.
WARNING:
„ Do not take any action during the update procedure, if the receiver has not restarted yet or if an error
message appears.
„ Do not disconnect the receiver from the mains nor switch o until the software update
has been completed.
7.4.10 Factory default
This submenu allows you to reset your receiver to the default factory settings. You will be asked to enter the
PIN code (default PIN code is 0000). Select OK to delete all settings and channels. Press OK to con rm.
WARNING:
A factory reset will permanently delete all your personal settings, timers and stored
channels. Please consider this before you perform a factory reset. Please use this option
with caution.
Default is "Astra 19.2 E" satellite. Select with t u other the satellite if it is
recommended.
Select with t u the recommended transponder.
Enter with nuberic keys the recommended value.
23
Advertisement
Table of Contents
