Table of Contents
Advertisement
7.1.4 Channel Search
Use this menu to perform an automatic, network or transponder channel search or to search on all
satellites that have been setup. Use pq to highlight an item and t u to change settings. Below are the
settings listed you can find in the search method selection.
Satellite
Transponder list
Scan Mode
Channel Type
Search Type
Scanning all the selected satellites is only available if more than one satellite has been setup.
When all settings have been made, press OK at the preferred scan method to start the scan process or
to quit without scanning. All new found channels will be stored at the end of the channel list.
NOTE:
NOTE:
7.1.5 Manual Search
This submenu allows to search on a specific transponder and to enter values for it. You can also create
new satellites with corresponding transponder data base.
Satellite
Transponder
Frequency:
Symbol rate:
Polarization:
Search One TP
Select the satellite on which you would like to search for channels.
Select a specific transponder you would like to search on. By pressing t u
you can change between the transponders referring to the selected satellite,
you can also press OK to list and select with pq or P+/P-. Afterwards press
OK to choose. Press RED to Edit TP, with BLUE you can Delete TP and with
GREEN you can enter data for a new transponder Add TP. Details of the
transponder are shown on screen.
Here you can decide which type of channels you want to scan for: Either
scan all channels ALL, for Free-To Air only FTA or use Scramble to scan for
scrambled channels only.
TV & Radio will scan for TV and radio channels, TV for TV channels only and
Radio for radio channels only.
Select if you would like to search all or only one satellite, Manual search only
on one Transponder or on a Network.
NIT (Network Identification Table): This option will scan for the NIT table of
the satellite and allows you to receive new appeared channels.
When you want to add technical data for a new transponder we
recommend verifying it by consulting websites like: www.lyngsat.com or
www.kingofsat.net or you can refer to professional publications.
Select the satellite to which you would like to add a new transponder. If you
select NewSat then you can start to create a new satellite.
By pressing t u you can change between the transponders referring to the
selected satellite. Select TP new to enter in the next step new transponder
values.
Enter a frequency with the 0 ~ 9 buttons.
Enter the required symbol rate with the 0 ~ 9 buttons.
The polarization can be changed with t u.
Press OK to start to search only this transponder.
15
Advertisement
Table of Contents
