Table of Contents
Advertisement
WARNING: A factory reset will permanently delete all your personal settings, timers and stored channels.
Please consider this before you perform a factory reset.
Upgrade by USB
Download the required update file for your receiver model from the support page on our website www.
strong.tv or contact your local dealer.
Unzip the file on your computer, if necessary, and copy it to root folder of your USB storage device. The USB
device must have been formatted in FAT32 on a PC.
Connect the USB storage device to the USB port of the receiver. Press MENU and select Tools, then Upgrade
By USB to update the software select at Upgrade Mode the option Allcode. At Upgrade File select the correct
upgrade file, the file has the extension abs.
Then select Start, and press OK to initiate the upgrade process. An attention banner will now be displayed.
Press OK to confirm Yes the update (or No to cancel it). The update process will take some time. After the
update process has been completed the receiver will restart and then show the first channel in the TV list.
You can now safely remove the USB device, and then remove the update software from the device (at the
PC), to prevent accidental updating again.
WARNING: NEVER power off the receiver or remove the USB device during the software update process.
Doing so might cause irreparable damage to your receiver and will void your warranty.
NOTE: In certain instances it can be advised on the website to upgrade the unit with the Maincode option
in stead of Allcode.
The bootlogo and Radioback are for Strong internal use.
7.3.6 Dump channel list
7.3.6.1 DB Management
This menu allows you to save and reload the channel Data Base of your receiver from/to a USB-device. This
very convenient feature enables you to save your personal settings like Channel-, Favourite-, Sat- and TP-lists
on an USB storage device and load them back to the receiver later.
Write to USB Dump Channel list
Select Update Mode, then Dump channel list and Start and press OK to make a backup of the data base,
including channels and user set data. An.udf file with the current time, date (day, month, year), will be
created on the USB device. When the database has been successfully stored a message will be displayed on
screen. Press
to leave the menu.
7.3.6.2 Load from USB Update channel List
Select Update Mode, then Update channel list. Select the file at Upgrade File you want to restore to.
Use t u for displaying the available database files (if any stored before). The.udf files are shown with their
built time, date (day, month, year) Select the file you want to load and then select Start to load the file. When
the database has been successfully loaded the receiver will reboot and switch automatically to the first
stored channel.
Remove USB safely Use this option to safely remove your USB device from the unit. It will prevent loss of
data and prevent hardware damage to such a device. This procedure is comparable working with a personal
computer.
8. A.1 TROUBLESHOOTING
There may be various reasons for abnormal operation of the receiver. Please check the receiver according
to the procedures shown below. If the receiver does not work properly after checking it, please contact
your local Service line or STRONG dealer. Alternatively, you can send a support mail via our website: www.
28
Advertisement
Table of Contents
