Update; Ca Menu - Strong SRT 7501 User Manual

7.5 Update

In this menu you can update the receiver via USB or OTA (= Over The Air /download via satellite). Select
the desired sub-menu using the pq buttons and press OK to continue.
7.5.1 USB Software Update
This function allows you to perform a software update using a USB storage device.
Download the appropriate software and update instructions from our website www.strong.tv and
unzip them to your correctly formatted storage medium. Load the file (s) into the main directory of your
storage device, then connect it to your receiver. Turn the receiver on and wait until the storage device is
successfully detected.
1. Wait a few seconds (~ 10 sec.) Until the receiver displays a message that new software is
available. If no message is displayed, please try another storage device!
2. Use the t u buttons to select OK and press OK to perform the update.
3. The receiver now changes to the update mode. Please wait until the update is complete!
4. Please remove the USB device as soon as the corresponding message is displayed from your
receiver!
To reboot after successful update, the USB device must be removed!
WARNING:
7.5.2 OTA Software Update
With the OTA (Over The Air) function, you can search for software updates via satellite. Ask your STRONG
dealer or visit our website www.strong.tv for more information. Only in the case of an available update
and appropriate handling the option will be available in the menu. It is possible that you can also receive
an update request after starting up the receiver. Updates which are broadcasted via OTA are intended to
improve and to enhance the product so it should be carried out in your own interest.
Press OK on the OTA Software Update menu. The receiver starts with the software search. Follow the
further instructions on screen.
WARNING:

7.6 CA Menu

This menu contains all important and necessary information about the integrated encryption system.
If there are problems with opening encrypted channels, these data can help the operator or the
servicehotline with finding a solution or hint.
22
NEVER disconnect the receiver from the mains or switch the power OFF
during the update procedure. It can damage your receiver and warranty will
void! In case of an USB software update please consider that the receiver
may delete all channels, data and user settings in certain cases.
After the update the receiver restarts automatically! During the update
process NEVER disconnect the receiver from the mains, switch power OFF
or disconnect the receiver from the antenna cable! This can damage your
receiver and warranty will be void! In case of an OTA update please consider
that the receiver may delete all channels, data and user settings in certain
cases.