Table of Contents
Advertisement
DiSEqC 1.1
Transponder
Press the RED button to start scanning on the selected transponder if selection is on Transponder.
Press the RED button to start scanning on the whole satellite if selection is on Satellite.
7.1.3 Motor Settings
If you use DiSEqC 1.2 or GOTO-X, you can install satellites which are received by a motorized dish. For
setup and installation as well as for correct setup of the positions in the receiver we highly recommend
taking the advice of a professional and experienced dish installer. The menu allows you to configure the
motor type and to adjust the motor position for the satellite which you want to receive.
Satellite
Transponder
DiSEqC Motor
Selection on DiSEqC 1.2
Move:
Move fine:
Limit:
Go To: Position
Save/Recalculation
Selection on GOTO-X
Configure the motor position through the GOTO-X function. Enter your geographical position. The
motor is able to find all available satellite positions itself.
Antenna Position:
GOTO:
NOTE:
14
Select a port 1 to 16 according to the connected satellite dish.
Press OK to open the list of available transponders for the chosen satellite, in
order to check your reception or align the antenna.
Press OK to open the list of available satellites and choose a satellite with pq
or P+/P- and confirm by pressing OK.
Press OK to open the list of available transponders if you need to adjust a
transponder for the above selected satellite.
Select between type DiSEqC 1.2 and GOTO-X or Off.
Press t u to move the dish to East or West. Carefully move until you can
observe that both signal bars show acceptable reception levels. When you
have found the selected satellite press and select Yes to save the position.
Here you can move the motor in small steps to adjust it more precisely.
Press OK to open this submenu in order to adjust mechanical limits for your
dish. This is only necessary if your dish could interfere with a wall, tree, or
similar mechanical margins.
Press OK to move the motor to the centre position of0 degrees. This is only
needed for the first time to adjust the dish correctly or select a number from a
position.
To store and save a position or do a recalculation.
Press OK to open submenu.
Use the 0 ~ 9 buttons to enter the value of your longitude.
Select East or West.
Use the 0 ~ 9 buttons to enter the value of your latitude.
Select North or South. At the end select Save and press OK to confirm the
values.
Press OK to move the motor to the wanted position
Detailed information about correct geographical values for your location
can be found on websites like dishpointer.com, itouchmap.com or other
reliable sources.
Advertisement
Table of Contents
