Connecting To Multiple Fixed Antennas; Connecting To Your Motorised Dish Via Diseqc; Extended Connections For Your Home Entertainment; Starting Up For The First Time - Strong skylink SRT 7502 Installation Instructions Manual

Table of Contents

OPTIONAL:

3.2 Connecting to multiple fixed antennas

a. Connect the LNBs of your fixed antenna to the desired inputs of a DiSEqC 1.0 switch using a

good quality coaxial cable and suitable 'F-connectors'.

b. Connect the output or "to receiver" output of the DiSEqC 1.0 switch to the SAT IN connector on

your receiver using a good quality coaxial cable and suitable 'F-connectors'.

c. Plug the power adapter jack to the receiver and the other end to a suitable wall outlet.

3.3 Connecting to your motorised dish via DiSEqC 1.2 or GOTO-X

Another possibility for watching programmes from multiple satellites is by mounting a dish to a

motorized DiSEqC 1.2 or GOTO-X positioner. For the correct setup and mounting of your motorised dish

we recommend referring to the advice of a professional satellite equipment installer to ensure correct

alignment and function. Please ensure that all connections are fitting well and are correctly assembled,

then you only need to connect the "OUT" connector of your positioner to the SAT IN connector on the

rear side of your receiver.

a. Connect one end of a good quality coaxial audio cable to the S/PDIF output of your receiver

and the other end to the coaxial audio input of your home theatre set, amplifier or any other

device supporting digital audio.

b. Connect your USB 2.0 storage device to this connector by using a good quality USB cable or

insert the device directly.

Ensure that your satellite signal is of good quality and that all connections are properly setup. In case you

encounter difficulties or you have questions, please ask your local dealer for assistance.

It is recommended to follow the First Time Installation step by step. It will guide you through the basic

setup and installation process. You will enjoy digital HD broadcasts within just a few minutes.

In the unusual/uncommon case that the receiver should not start-up within the First Time Installation,

please reset the receiver with the factory reset DEFAULT PIN: 0000).

Please insert your valid and activated Irdeto smartcard for proper reception of the channel bouquet of

your choice.

If your TV set doesn't have an HDMI connector you can use the SCART

connection instead. In such case connect one end of a good quality SCART

cable to the TV SCART of your receiver and the other end to the SCART input

of your TV set.

Fig. 7.

Fig. 8

Fig. 9

Table of Contents