Pepperl+Fuchs VisuNet Control Center 6 Manual page 63

VisuNet Control Center 6
Manage (Device)
• Either follow the RM Shell First Start Wizard steps locally on the device or remotely via
VisuNet CC. For further information on the First Start Wizard please refer to the RM Shell
manual.
• Enter the System Settings App of the RM Shell (Chapter 7 RM Shell Manual) and set the
computer name of your device.
• If your Network requires static IPs, also adjust the IP Settings. If the DHCP is enabled this
step is obsolete.
• Reboot your System so that the changes take effect.
2. Backup Image
After the automatic rebooting of the System the device will be found automatically in VisuNet
CC. All settings can be adjusted as usual if necessary.
Note! Make sure not to change the Computer Name and the IP address in between the captur-
ing and applying process. VisuNet CC might to be able to find the device and a local setup
might be required.
3. Clone Image
After the reboot of the device you need to change the following settings locally.
• Close the Window "First Start Menu"
Figure 7.47
• Enter the System Settings App of the RM Shell (Chapter 7 RM Shell Manual) and set the
computer name of your device.
• If your Network requires static IPs, also adjust the IP Settings. If the DHCP is enabled this
step is obsolete.
• Reboot your System so that the changes take effect.
• Continue the setup process via VisuNet CC. If you already configured your RM Shell
device settings in the past und would like to restore these settings follow a). If you would
like to configure multiple devices with the same configurations follow b)
63