Pepperl+Fuchs VisuNet Control Center 6 Manual page 15

VisuNet Control Center 6
VisuNet CC Setup
Figure 5.6
Function
Open/Close Timeout
Connection Timeout
Refresh Cycle Timeout
Maintenance Access Tim-
eout
Max simultaneous Actions: Specifies the number of actions performed simultaneously.
In the log settings you can choose which Control Center events are being loged in the log file
and where this will be stored on the local machine.
Description
Specifies the time VisuNet CC waits for an answer from the RM /
BTC during establishing/closing of a connection before a timeout
occurs. Increase the timeout, when there are problems establish-
ing a connection to device.
Specifies the time VisuNet CC waits for an answer from the RM /
BTC when a connection has been established before a timeout
occurs.
Specifies the time intervals in which VisuNet CC automatically
polls the connected RM / BTC for new device information.
Increase the timeout, if connections are interrupted at short
notice from time to time.
Specifies the time the local operator is given to respond to the
dialog prompt before the maintenance mode is automatically
entered.
Note: Multiple simultaneous action can cause high network traf-
fic, resulting in high latencies for other devices on the network.
15