05. SYSTEM OPERATION
05.01. PARAMETER AUTHORITY
05.01.01. AUTHORITY STRUCTURE
LEVEL
Operator
Technician
Developer
05.01.02. ACCESS RIGHTS TO THE TECHNICIANS LEVEL
NOTE!
Normally, only the operator has basic authority. The symbol is gray. The technicians level is not to be accessed
by normal users. Modifications at this level must only be done by service sta .
The technicians level is unlocked by the following:
At Main sewing interface, press icon
click will be ignored.
05.02. QUICK RESET ALL PARAMETERS
1
Press return button
sage near the wait cycle animation.
03/2023
20
YSC-90A0 INSTRUCTION BOOK
ACCESSIBLE PARAMETER
Basic parameters
Advanced Parameters
Parameters about motor drive
to enter „Authority interface". If not done at the main sewing interface, the
when switching on the controller. The controller will make a factory reset. There will be a mes-
ICON
1