Sewing Foot Lift; Thread Trim - VETRON 4000 Instruction Manual

06.06. SEWING FOOT LIFT

INDEX MAX
A09 1
T05 500
T06 500
T07 999
T10 200
A14 1
A15 1
O05 100
O06 1
O07 30
Sewing foot lift at sewing stop: click
Sewing foot lift after trim: click
Foot timed release: the max. time that the foot can be permanently raised is restricted by parameter O07, after the
time has elapsed it is lowered automatically and can only be raised again by stepping the pedal backwards (-1 position).
From this time the restriction time is e ective again. This function is switched o with O06=0.
Holding force of the raised foot: the foot lifting is raised by full activation, then it switches automatically to partial ac-
tivation to reduce the load on the controller and the connected magnets. The full activation period is set with T07 and
holding force during partial activation is set with O05.
When pushing the pedal forward, with a raised sewing foot the start up delay, which can be set with parameter T06.

06.07. THREAD TRIM

-1-2
INDEX MAX
A06 1
S07 300
A42 1
D03 359
D04 359
MIN UNIT
0 -
1 ms
1 ms
1 ms
1 ms
0 -
0 -
1 %
0 -
5 s
at Main sewing interface, icon is on, the function is ON.
at Main sewing interface, icon is on, the function is ON.
MIN UNIT
0 -
150 rpm
0 -
0 degree
0 degree
DESCRIPTION
Sewing foot lift:
0 = OFF
1 = ON
Lifting foot confirm delay time:
to avoid unexpected foot lifting when stepping backward for
trimming, the time is less and the sensitivity is higher
Release lift foot delay time
Full activation duration of foot lift solenoid
Pedal delay time adjustment for debounce
Foot lift at sewing stop
0 = OFF
1 = automatic lifting the sewing foot during stop
Foot lift after thread trim:
0 = OFF
1 = automatic lifting the sewing foot during stop
Duty cycle in time period which PWM activation
Foot lifting solenoid automatically power o :
0 = OFF
1 = ON
Hold time before foot lifting solenoid automatically power o
DESCRIPTION
Thread trim:
0 = OFF
1 = ON
Thread trimming speed
Short thread cutter
Thread trimmng power on angle
Thread trimming power o angle
03/2023
YSC-90A0 INSTRUCTION BOOK
29