VETRON 4000 Instruction Manual page 72

06.02.01. COMMON SETTING ABOUT START/END TACKING
INDEX MAX
S03 2000
S04 2000
T01 200
T02 200
D05 359
D06 359
A20 1
A22 1
T11 1000
06.02.02. STITCH IN STITCH
Before adjustment, make sure that forward stitch length is the same with backward stitch length. Use the reverse lever.
NOTE:
Cannot be set for decorative tacking (SD Mode, A20, A22)
The time required for the actuator to move backwards can be set with parameter T01. See the following figure:
The time required for the actuator to move backwards can be set with parameter T02. See the following figure:
03/2023
24
YSC-90A0 INSTRUCTION BOOK
MIN UNIT
500 rpm
500 rpm
1 ms
1 ms
0 degree
0 degree
0 -
0 -
1 ms
Decrease T01
Decrease T02
DESCRIPTION
Speed in backtack at seam begin
Speed in backtack at seam end
Reverse solenoid action time (Start)
Reverse solenoid release time (End)
Reverse power on angle
Reverse power o angle
Ornamental-stitch backtack at seam start
0 = OFF
1 = ON, the motor will stop at sewing direction changing point
Ornamental-stitch backtack at seam end
0 = OFF
1 = ON, the motor will stop at sewing direction changing point
Stop time for sewing direction change of individual backtack
sections in order to reach the specified stitch lengths (forwards/
backwards)
Increase T01
Increase T02